power sander การใช้

• Sand to the bare wood, using a power sander.
• Less sheet sandpaper is needed if power sanders are used.
• Is there any way to smooth these walls without sanding with a power sander?
• Indoors, I suggest you use a power sander to strip to the bare wood.
• Even with power sanders, many carpenters agree, the final sanding should be by hand.
• If sanding a small area is satisfactory, then do the whole hearth with a power sander.
• Use a power sander; start with pretty coarse paper and work 9ouS way up to fine.
• Now, sand the old laminate with a power sander to reduce gloss and roughen the finish.
• If it were varnished ( unlikely ), reconditioning is the same : Sand with a power sander.
• When power sawing or using power sanders, wear protective goggles to protect your eyes from flying particles.
• You can use a power sander, but work carefully because it can quickly cut into the soft wood.
• Also keep in mind that most power sanders do not operate in a strict linear, that is back and forth, motion.
• Sand with a small power sander, being careful to keep the surface even, with no ripples or high or low spots.
• You could put the dish right on the tile, but you must sand the tile with a power sander first to roughen the surface.
• Second, sand the laminate heavily with a power sander, to reduce any gloss and roughen the finish to allow adhesive to stick to it.
• This Barbie needed the padded brassiere because she was flat-chested, courtesy of a power sander that made off with the doll's legendary bust.
• My husband sanded the inside of the chest with a power sander; the odor remained, and the sanding did not reveal any cedar odor, either.
• The floors, ceilings and woodwork were stripped to the bone, leaving behind romantic, faux-decayed surfaces that looked ready for an appointment with a power sander.
• Whether natural or stained, the cure for the roughness to lighten the gray is the same : Sand heavily, with a power sander, to the bare wood.
• Seems like you could speed things up if you dumped the emery board and took a power sander to the wart area, although I imagine that would be really loud.